Drill Bit Depth Stops That Grip & Hold. No Slipping!

Typical drill depth stops have set screws that are easy to cam out, don't always grip very well, or sit evenly on the bit. The unique two part, dual set screw design of our Universal Adjustable Drill Depth Stops addresses these shortcomings. All one needs to do is slide two halves of the depth stops slide over your bit to the desired stopping point. Then tighten each screw just until resistance is encountered, alternating back and forth until each screw is fully tightened. This ensures consistitent grip and seating, even on bits with very large or oddly shaped flutes. No more accidentally overtightening to avoid slipping down or off the bit, or crooked seatings.

The 101-115 depth stop is designed to work with drill bit sizes from 1/8" to just over 1/4" and will also work with complimentary sized metric bits. 

The 101-116 depth stop is designed to work with drill bit sizes from 1/4" to just over 1/2" and will also work with complimentary sized metric bits. 

The unique design makes set-screw cam-out a thing of the past. The depth stop gets a more secure grip on bits without overtightening , and is easier to seat square to the axis of the bit

The depth stops also have rounded bottom edges to avoid marring your workpiece. No need to come back and sand to remove ugly tooling marks. Each depth stop is supplied with the appropriate Allen wrench to adjust the fit. Be ready for any task (and save some money) by buying the 2-Piece set!