No More Frustrating Layout Calculations - It's Quick & Easy With This New Tool!
How do you mark your material to layout a row of screws, pins or dowels? Do you find it quick and easy or a real hassle? Without the MPower Point - 2 - Point Layout Tool the usual process is confusing and frustrating. You measure the length of the run and divide by the number of points plus one, then divide the extra one point by two and that gives your starting and finishing points. Then measure out each of the remaining points by the total on the calculator.
With the MPower Point - 2 - Point Layout & Measuring Tool the same job is quick and easy. Extend the Point - 2 - Point™ fully and then bring the mechanism down to the required size. Lock the setting in place with the Point-2-Point's™ pinch bolts and you're ready to start marking out, it's that easy!
- Consists of 8 x stainless steel points
- Extends to a maximum of 2ft (600mm)
- 4 x Brass pinch bolts lock the mechanism in place
- Multiple uses: woodwork, sewing, general craftwork, even in the kitchen